Acrylic: Brushed Antique Gold / Black Durra-Bull™ Laserable Panels (12"x24")
Acrylic: Brushed Antique Gold / Black Durra-Bull™ Laserable Panels (12"x24")
Couldn't load pickup availability
Think OUTSIDE of the box, and bring your creations to life with our stunning Brushed Antique Gold / Black Durra-Bull™ Laserable Acrylic Panels!
Backed by the best adhesive for a secure and lasting hold, the potential impact of your project is limitless!
Order of colors:
Brushed Antique Gold (will have clear, removable film on it to prevent scratching), Black
Heat Press Settings:
IQ setting: Top 280°F / Bottom 320°F for 45 seconds
Single Platen: 300°F for 50 seconds.
Panel size:
Each panel is1/16" or 1.5mm thick (minor, slight variations are normal), and APPROXIMATELY 12" x 24" (or slightly longer). The adhesive sheets are precision cut to exactly 12" x 24" and squared up with one corner of the panel, so there may be some acrylic not backed with adhesive along one or two edges.
Each (12" x 24") panel will effortlessly fit 36 (2.5" x 2.5") patches.
Tips: Remove the clear protective film on the FRONT of the acrylic panel before engraving. Yes, the adhesive will be bubbly on the back of the panel, as acrylic is nonporous and the functionality of the adhesive will not be affected. Clean the surface of the acrylic with soapy water and towel, or a gentle baby wipe, after engraving.
Share
Easy to work with and engraves nicely! I wish there was a backing on the adhesive though.
Great stuff to work with. Makes great trophy plates.
This was the key item I needed from my order of multiple items but was the worst in the lot. I expected for the sheets to be flat and crisp as they appear in the picture- not the case.
All of them were bent into a curve - almost curled at the ends. Due to the warping I can’t use them as they came. I reached out to the seller and to be fair I asked if there was a way to fix them or can exchange. The response was less than I had expected - no acknowledgement of inconvenience or the poor quality just direction to use a heat press or iron to fix them I. A sentence or two.
Not a good look / first impression for a first time buyer. Won’t be buying again. Unfortunate.
This copper looks and cuts beautifully. I don’t recommend doing larger pieces for hats unless it’s on a flat bill just because the acrylic kinda pushes against your head. However, great product!! It cuts sooo nice!
Hat press setting recommendations:
230 degrees
45seconds
Use heat tape and press 2 times remove heat tape after first press
I was so nervous to use this at first, but I finally got the courage to try it and all i can say is wow, this this stunning, The quality of the product is unbeatable!!!!
